International Journal of Instrumentation Control and Automation IJICA
ISSN: 2231-1890

Abstracting and Indexing

IJICA
Distributed data acquisition and control system based on low cost Embedded Web servers
Joby Antony
Cryogenic Control, Inter University Accelerator Centre (IUAC),
Basanta Mahato
Electronics and Communication (Microelectronics and Embedded Technology) Department, JIITU,
Sachin Sharma
Distributed data acquisition and control system based on low cost Embedded Web servers,
Gaurav Chitranshi
Electronics and Communication (Microelectronics and Embedded Technology) Department, JIITU,
Abstract
In the present IT age, we are in need of fully automated industrial system. To design of Data Acquisition System (DAS) and its control is a challenging part of any measurement, automation and control system applications. Advancement in technology is very well reflected and supported by changes in measurement and control instrumentation. To move to highspeed serial from Parallel bus architectures has become prevalent and among these Ethernet is the most preferred switched Serial bus, which is forward-looking and backwardcompatible. Great stride have been made in promoting Ethernet use for industrial networks and factory automation. The Web based distributed measurement and control is slowly replacing parallel architectures due to its non-crate architecture which reduces complexities of cooling, maintenance etc. for slow speed field processing. A new kind of expandable, distributed large I/O data acquisition system based on low cost microcontroller based electronic web server[1] boards has been investigated and developed in this paper, whose hardware boards use 8-bit RISC processor with Ethernet controller, and software platform use AVR-GCC for firmware and Python for OS independent man machine interface. This system can measure all kinds of electrical and thermal parameters such as voltage, current, thermocouple, RTD, and so on. The measured data can be displayed on web pages at different geographical locations, and at the same time can be transmitted through RJ-45 Ethernet network to remote DAS or DCS monitoring system by using HTTP protocol. A central embedded single board computer (SBC) can act as a central CPU to communicate between web servers automatically.
Recommended Citation
[1] http://tuxgraphics.org/electronics/
[2] http://www.fz-juelich.de/portal/homeJ
[3] M.Babita Jain, Amit Jain, M.B.Srinivas, 2008”A Web based expert
systems shell for fault diagnosis and control of power systems
equipment “, IEEE, pp1310-1313.
[4] Tao Lin ,Hai Zhao ,Jiyong Wang ,Guangjie Han and Jindong
Wang ,”An Embedded Web Server for Equipment ”,School of
Information Science & Engineering, Northeastern University,
Shenyang, Liaoning, China.
[5] Clyde C. W. Robson, Samuel Silverstein, and Christian Bohm
(2008) An Operation-Server Based Data Acquisition System
Architecture IEEE Transaction on Nuclear Science, Vol. 55, No.1.
[6] http://www.commandprompt.com/community/pyqt/